Paradyne 6211 Bridge/Router Combo

1. Log into your 6211's management interface. This is normally done by going to http://192.168.1.1 in your web browser. The default username is "Admin" and the password is "Admin"
2. Click Setup across the top. Place a check in "Enable Firewall and NAT Services", click Apply at the bottom.
3. Login again after the router reboots.
4. Click Setup across the top.
5. Click "WAN Bridge" on the left. Click Delete at the bottom.
6. Click "New Connection" on the left and set the following options:
   1. Name: VCI
   2. Uncheck Firewall (without this your connection may not work)
   3. Set the Username and password as the username and password you gave VCI. Ensure you put your full VCI email address in as the username (example: myname@vci.net)
   4. Place a check in "Default Gateway"
   5. Click Apply at the bottom
   6. If you click Connect your connection should be made to VCI.
7. If you will not be using the Wireless AP disable the wireless functionality for security reasons. Click Wireless across the top, then Configuration and remove the check from "Enable AP". Click Apply
8. To save these settings click Tools across the top, "System Commands" and then "Save All"